Smoke Alarm Cover Removal. Unfortunately over time plastic will become brittle and may be incredibly hard to unclip. Open the cover and remove the battery.
Open the cover and remove the battery. With the removal tool still inserted, slide the lower half of the alarm away from the removal tool in the direction of the arrow on the cover. Turn off the breaker controlling the alarm circuit or disconnect the smoke detector from the circuit.
Table of Contents
Replace The Battery Cover And Hold The Smoke Detector Up Against The Mounting.
At least one smoke alarm should be installed in the escape route on all floors of the building. Learn how dust covers can protect alarms during remodeling or painting. Looks like its clipped into place, you need to pry that cover down.
This Video Shows How To Remove An Ei141 Ionisation Smoke Alarm From Its Base Plate.
When the area has been cleaned, you can remove the cover. How do you disconnect a smoke alarm? If the alarm doesn't budge when you twist it, you may need to disengage the locking pin to.
Step By Step, Here's How To Change A Smoke Detector Battery:
The detection element of smoke alarms should be between 25mm and 600mm below the ceiling, or in the case of heat alarms between 25mm and 150mm I think it's the ei141 model. The battery compartment should be visible on the back side of the detector, remove the cover and replace the battery.
Disconnect The Ac Power Harness By Squeezing The Locking Arms On The Sides Of The Quick Connector While Pulling The Connector Away From The Bottom Of The Alarm.
You'll either be buying a new smoke alarm or patching a ceiling. I've tried all kinds of different screw drivers inserted where instructed but the alarm cover will not slide off. Dust covers protect detectors from harmful debris during construction, renovation, or painting.
1Cm Into The Alarm's Removal Slot And Lever It Down Gently.
You slide it the way the arrow shows, possibly will need a little love tap 🙂 Turning the detector clockwise should reattach it to the mount. Wrap the piece of aluminum foil around the smoke detector.