Whirlpool Duet Dryer Won't Start Stuck On Sensing Guide 2022. Unplug the dryer and look behind the lint filter enclosure to the left. If the dryer is not level, the sensing does not work properly, and your drying cycle will end early.
Empty your wet laundry into a tray. Here's the control board for your model you can order here: Remove it from it's bracket and turn it over.
Table of Contents
The Electronic Control Is Located On The Left Side Panel Near The Top.
If the sensing light keeps flashing, the dryer is most likely stuck on sensing. Empty your wet laundry into a tray. Why your whirlpool duet dryer won’t start.
As Your Load Of Laundry Tumbles In The Drum, It Makes Contact With The Sensor Strips So That The Dryer Can End The Cycle When Your Laundry Is Dry.
All whirlpool duet dryers have sensor strips in the drum. You'll probably see a burn mark near the relays. That’s why your whirlpool dryer is stuck in sensing mode.
Unplug The Dryer And Look Behind The Lint Filter Enclosure To The Left.
Whirlpool duet dryer won't start stuck on sensing. As your load of laundry tumbles in the drum, it makes contact with the sensor strips so that the dryer can end the cycle when your laundry is dry. After spending countless hours researching why our dryer would not spin, but would turn on and had no error codes, i thought why not make a short video and b.
Replace The Control And You're Back In Business.
Suppose your dryer is electric; Defective circuit board (or controller) bad moisture sensor; Power not reaching the dryer;
If The Dryer Is Not Level, The Sensing Does Not Work Properly, And Your Drying Cycle Will End Early.
Remove it from it's bracket and turn it over. A problem with the door switch Here is a straightforward process of cleaning your whirlpool dryer’s tub: